Handyman Wire

Who's Online
2 registered (RCovell, 1 invisible), 43 Guests and 1 Spider online.
Key: Admin, Global Mod, Mod
Welcome Newcomers
Unregistered users may only post in the handyman forum. If you register, you may post in any forum and use of CAPTCHA code is not required.
Advertisement
Active Topics | Active Posts | Unanswered Posts Past 24 hours | Past 48 hours | Past 7 days
Forum   Subject
Around the shop
Jump to new posts 9 people who have conquered nature by rfm3 @ 05/15/13 07:04 AM

9 people who conquered nature. I am sure there are others.
Around the shop
Jump to new posts Re: True, true.... by JasonB @ 05/15/13 06:44 AM

LOL. Humor helps. J
Around the shop
Jump to new posts Re: WTF is going on here???? by JimTheTinkerer @ 05/15/13 06:43 AM

It seems there was a leak about CIA efforts to thwart Yemen-based terror planning against the US. That's the 'story'. Heads I win, tails you lose?? Complain about the taking of records and you're defending against the 'police state'. If they go bl
Around the shop
Jump to new posts Re: .05 by JimTheTinkerer @ 05/15/13 06:36 AM

A bit obsessive. The Mothers Against Drunk Driving rep is not too sure about this one, either. They see trouble, and better ways to stop fatalities. One reason you can drink Ethanol without poisoning yourself it that it's used in your body.
Plumbing
Jump to new posts Re: Extremely slow drip from tub valve by Clint_Robbins @ 05/15/13 06:27 AM

Quote: That chunk wasn't there when I installed the cartridge the first time. It showed up when I pulled the new cartridge out after I installed it the first time. Whenever a water supply is turned off and on again, even if no plumbing work is done,
Around the shop
Jump to new posts True, true.... by Uncle_Alvah @ 05/15/13 06:21 AM

Around the shop
Jump to new posts Re: Daughters decision-kinda long, rambling by JimTheTinkerer @ 05/15/13 06:00 AM

Remember, you have experience that's running out in the dwindling population behind you. I've felt better about temp work...short term can give you more experience to landed a long-term. Act well-seasoned and someone may order the dish.
Around the shop
Jump to new posts Re: Made it!!!!!!!! by JimTheTinkerer @ 05/15/13 05:56 AM

Congrats...and while you can still dance! Takes a steady hand at the tiller.
Around the shop
Jump to new posts Re: Fishing line by mommapup. @ 05/15/13 05:55 AM

Just go to WalMart or Bass Pro and get an "Ugly Stick". You'll get great service out of it, and they're not pricey.
Around the shop
Jump to new posts Re: Speaking of non-profits... by CabinConnection @ 05/15/13 05:54 AM

Originally Posted By: Bob_FlemingBoy, I've never seen a Goodwill store like that one! You need to get out more, Bob. The one shown is "typical" of what I see all over the country now.
Around the shop
Jump to new posts Re: X47-B Navy Drone by JimTheTinkerer @ 05/15/13 05:53 AM

They could have launched drones before, but only little ones. The big thing with this size drone is that it can stay up for a lot longer than a fighter and it can deliver a few pieces of precision ordinance. No need for a dogfight chain gun, cockpit
Around the shop
Jump to new posts Re: Made it!!!!!!!! by CabinConnection @ 05/15/13 05:49 AM

Oh... That'S GREAT! Congrats!
Around the shop
Jump to new posts Re: Made it!!!!!!!! by Uncle_Alvah @ 05/15/13 05:47 AM

50 years is a great milestone, Congrats! I have been married for 28 years.....but it's taken me three wives to reach that point....
Around the shop
Jump to new posts Re: X47-B Navy Drone by Just_Bill @ 05/15/13 05:41 AM

Computer controlled takeoffs have been around for a while, but the landing can't be done that way, that I know of. Too many variables. Moving, pithcing ship, angled deck, wind, etc.
Around the shop
Jump to new posts Re: Made it!!!!!!!! by bilvihur @ 05/15/13 05:35 AM

My wife and I have shared 5 happy years together. The other 40 have been unrelenting misery...
Handyman
Jump to new posts Re: How to cement fence posts by Just_Bill @ 05/15/13 05:35 AM

What Bob said, or don't use concrete at all, but pack around the post with crusher run or similar(no pea gravel) and tamp well. That allows drainage and will hold the post tightely.
Small Engine Repair
Jump to new posts Re: Troy bilt tiller Briggs motor mystery wire by JasonB @ 05/15/13 05:35 AM

The wire goes to a cylindrical device on the float bowl, about 3/4" diameter and 2" long? That's a fuel cut-off solenoid. It's energised whenever the engine is running, allowing fuel flow. on shut-down, it cuts off fuel flow, in part to
Around the shop
Jump to new posts Happy Happy Happy by Uncle_Alvah @ 05/15/13 05:32 AM

Just finished reading Phil Robertson's book "Happy Happy Happy". I much enjoyed it. Fans of "Duck Dynasty" see the Robertson's as they are now, but this book gives great insight into how "things used to be". Phil was in
Around the shop
Jump to new posts Re: Funny Kitten Video by JasonB @ 05/15/13 05:31 AM

Our sheltered indoor cat doesn't really react to the smoke detector.... Light a Mapp gas torch, however, and she can levitate, claws simultaneously existing in all locations within a 12" radius of her.... Kinda hilarious, if you're not in her
Around the shop
Jump to new posts Re: Made it!!!!!!!! by JasonB @ 05/15/13 05:29 AM

Wow, Congratulations on 50 years! Hope to make it there one day.... Long way off! J
Around the shop
Jump to new posts Re: X47-B Navy Drone by JasonB @ 05/15/13 05:23 AM

Yessir, landing's the trick!
Woodworking / Hobby Shop
Jump to new posts Re: Mesquite Elephant Work in progress by JasonB @ 05/15/13 05:16 AM

Very nice! Can't wait to see it all finished, when the shapes and grain "pops". J
Small Engine Repair
Jump to new posts Re: Troy bilt tiller Briggs motor mystery wire by saugen48 @ 05/15/13 05:10 AM

Can you get the Mod number off of it
Plumbing
Jump to new posts Re: Right connectors for these pipes by sportster @ 05/15/13 05:00 AM

Dora, Sterling does not give a depth (at least from what I've seen) on their spec sheets for the shower enclosures. I am going to be installing a model# 72220100. If I were to use the type of coupler that you have listed I will need to get below the
Around the shop
Jump to new posts Re: Gosnell Guilty by Bob_Fleming @ 05/15/13 03:56 AM

Why, he was providing "women's health" services, the way H. Clinton tells it.
Page 27 of 34 < 1 2 ... 25 26 27 28 29 ... 33 34 >


Experts | Email Us | Disclaimer | HandymanWire home
Articles | We welcome your feedback. | Privacy
http://www.handymanwire.com
Handyman Wire
your resource for advice on home improvement and repairs.
Copyright ©2012, Handyman USA LLC.
All rights reserved.